![]() Sometimes you may need to return to previous states of a document file, for example, if it wasn’t saved by mistake. In case of normal end of work with a document, autosave files are automatically deleted. Usually, files created as a result of autosave can be useful only in case of abnormal end of the program session, since in this case these files remain on the disk. ![]() Saving File History and Possibility to Return to Previous States To recover data from a backup copy, change the file extension to *.dwg. Backup copy allows the user to recover information and minimize losses of information by means of periodic savings (for example, every 15-20 minutes) of the file by the user.īackup copies are saved in the folder where the document file is saved.īackup parameters are specified in the AutoSave and Backup section of the Options dialog box ( Tools menu > Options): Different contingencies can occur with a document during the working process, for example, malfunctions of hardware, failure of the software or improper actions of a user. Original backup copy (file with *.original extension) saves document data as it was when the file was opened for editing (original backup is created at the beginning of the session of file editing).īackup copy (file with *.bak extension) is often updated during the document editing process (at every saving by the user). In future sessions, this file will not be overwritten/saved if the path for the Backup folder (in AutoSave and Backup section in Options dialog ) was not changed or the backup file was not deleted. The original backup copy is created only once – on the first editing session. Original Backup copy (file *.original) stores content of the opened or new (but saved!) as it was on first save command. NanoCAD creates two backup copies of the file with the same name, but with different extensions. Ignores the automatically saved version and opens the original document (if it exists).ĭeletes the automatically saved versions. Opens the autosaved file with all changes made when the document was autosaved last time. To recover document data, click on the file name and select one of the following in the context menu: The first launch of nanoCAD after a failure starts from the Recover documents dialog box, containing information about the original file (name, path and creation time) and last autosave time. To switch off auto saving, set 0 for this parameter. The auto saving parameters are specified in the AutoSave and Backup section of the Options dialog box ( Tools menu > Options): To open and work with an auto saved file, change its extension to *.dwg (delete the additional information in round brackets and the *.autosave extension). ![]() The document is saved into the specified folder only after it is opened again. Attention! If you specify another folder for autosaving, the current (open) document is autosaved into the previous folder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |